uk es it fr pt nl
Takegashima Notaciones
Calidad cuándo Funciona: 3.0
Consistencia de Olas: 4.0
Dificultad: 4.0
Gente al Agua: 3.0

Overall: 3.7

Ver todas las 18 notaciones

Basado en 1 voto. Votar


Surf Report Feed

Estadísticas de Olas para Takegashima, octubre: Todo Oleaje – Todo Viento

This chart illustrates the variation of swells directed at Takegashima through a typical October. It is based on 2976 NWW3 model predictions since 2006 (values every 3 hours). The wave model does not forecast wind and surf right at the shore so we have chosen the best grid node based on what we know about Takegashima, and at Takegashima the best grid node is 18 km away (11 miles).

The rose diagram illustrates the distribution of swell directions and swell sizes, while the graph at the bottom shows the same thing but lacks direction information. Five colours illustrate increasing wave sizes. Blue shows the smallest swells, less that 0.5m (1.5 feet) high. These happened only 34% of the time. Green and yellow illustrate increasing swell sizes and red represents the largest swells, greater than >3m (>10ft). In both graphs, the area of any colour is proportional to how frequently that size swell happens.

The diagram suggests that the prevailing swell direction, shown by the biggest spokes, was ESE, whereas the the most common wind blows from the NNE. Because the wave model grid is away from the coast, sometimes a strong offshore wind blows largest waves away from Takegashima and out to sea. We lump these in with the no surf category of the bar chart. To keep it simple we don't show these in the rose diagram. Because wind determines whether or not waves are surfable at Takegashima, you can select a similar diagram that shows only the swells that were predicted to coincide with glassy or offshore wind conditions. Over an average October, swells large enough to cause good for surfing waves at Takegashima run for about 66% of the time.

IMPORTANT: Beta version feature! Swell heights are open water values from NWW3. There is no attempt to model near-shore effects. Coastal wave heights will generally be less, especially if the break does not have unobstructed exposure to the open ocean.