uk es it fr pt nl
Anse Bertrand Notaciones
Calidad cuándo Funciona: 1.3
Consistencia de Olas: 1.3
Dificultad: 1.0
Windsurf y Kitesurf: 1.0
Gente al Agua: 3.3

Overall: 2.0

Ver todas las 18 notaciones

Basado en 3 votos. Votar


Surf Report Feed

Estadísticas de Olas para Anse Bertrand, Invierno: Todo Oleaje – Todo Viento

This chart describes the combination of swells directed at Anse Bertrand over a normal northern hemisphere winter. It is based on 7765 NWW3 model predictions since 2006 (values every 3 hours). The wave model does not forecast surf and wind right at the coast so we have chosen the optimum grid node based on what we know about Anse Bertrand, and at Anse Bertrand the best grid node is 30 km away (19 miles).

The rose diagram describes the distribution of swell sizes and swell direction, while the graph at the bottom shows the same thing but lacks direction information. Five colours illustrate increasing wave sizes. Blue shows the smallest swells, less that 0.5m (1.5 feet) high. These occurred only 54% of the time. Green and yellow represent increasing swell sizes and red shows highest swells greater than >3m (>10ft). In both graphs, the area of any colour is proportional to how often that size swell happens.

The diagram indicates that the most common swell direction, shown by the largest spokes, was NNE, whereas the the dominant wind blows from the E. Because the wave model grid is offshore, sometimes a strong offshore wind blows largest waves away from Anse Bertrand and away from the coast. We combine these with the no surf category of the bar chart. To avoid confusion we don't show these in the rose plot. Because wind determines whether or not waves are clean enough to surf at Anse Bertrand, you can view an alternative image that shows only the swells that were forecast to coincide with glassy or offshore wind conditions. During a typical northern hemisphere winter, swells large enough to cause surfable waves at Anse Bertrand run for about 5% of the time.

IMPORTANT: Beta version feature! Swell heights are open water values from NWW3. There is no attempt to model near-shore effects. Coastal wave heights will generally be less, especially if the break does not have unobstructed exposure to the open ocean.